[<<]Message[>>]    [<<]Author[>>]        Subject[>>]        Thread[>>]

Number   :  5334
Date     :  2003-08-16
Author   :  Colin Culpitt-Smith
Subject  :  "Insufficient memory"
Size(KB) :  0


Can anyone help with this please?

I have successfully used XXCOPY under Win98SE to clone my boot drive (HD1)
to a slave drive (HD2). I then reformatted HD1, & tried to copy HD2 back to
HD1, using XXCOPY16 under true Dos. This was part of an experiment to find
a fix for the long filename problem! More of this later, as I'm sure I have
a fix!

All seemd to go well, until XXCOPY16 aborted with the error message, "
Insufficient memory (Job too large) Cannot continue". On checking HD1, I
found that only some of the folders/files had been copied. I ran XXCOPY16
again, & more folders/files were copied, but it aborted with the same error
message as before.

I have a modern 2gHz CPU with 512mB of memory, so why does XXCOPY16 fail?

I tried using various XXCOPY16 switches:- /clone , /bu , &
/c/e/h/k/r/y/pb - but all had the same result.

I'm now at a loss as to how to get XXCOPY16 to run normally. Can anyone
advise please?

Thank you very much.

From Colin Culpitt-smith



This message if part of XXCOPY's message Archive.
The archive contains all the messages posted at Yahoo!Groups: XXCOPY.